The crossmember is completely welded from the front, rear and both sides. The small crossmember provided was welded on the main crossmember, in order to accomodate for the new engine mounts.The small crossmember provided was welded on the main crossmember, in order to accomodate This is the new power steering which will be attached to the crossmember and new spindles. The power steering is bolted to the crossmember. An impact gun is used to fasten the power steering to the crossmember. Then the power steering is secured and torqued by hand to prevent overtightening.The power steering is bolted to the crossmember. An impact gun is used to fasten the power The inner fenderwells are cut out to make room for the new upper coil pocket that will be welded to the frame. The coil pocket is also bolted to the new upper control arms.The inner fenderwells are cut out to make room for the new upper coil pocket that will be « | 1 | 2 | 3 | 4 | 5 | » | View Full Article By Saul Vargas Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
