The lower control arms are bolted to the crossmember. The old factory engine bushings are removed. New polyurethane bushings will replace the old rubber ones. The wire wheel was used on both sides where ever the crossmember is to be welded to the frame to ensure proper contact.The wire wheel was used on both sides where ever the crossmember is to be welded to the fr The crossmember is tack welded in from the front, rear and sides, and then the clamps are removed.The crossmember is tack welded in from the front, rear and sides, and then the clamps are « | 1 | 2 | 3 | 4 | 5 | » | View Full Article By Saul Vargas Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!