Lowrider Cars, Girls, Pictures and Car Shows at LowRiderMagazine.com
Newsletter

The Rebirth - Audio Tech

A Bangin' System Can Breathe New Life Into A Crowded Trunk.

By Mario Escamilla, Photography by Mario Escamilla
  • Audiotech Rebirth Fleece Covering
    With our stapler in hand, we begin the process of stretching fleece over the area.
  • Audiotech Rebirth Ready For Resin
    All stretched and ready for resin.
  • Audiotech Rebirth Fiberglassing Rack
    The entire surface was soaked with resin and fiberglass mat was applied for additional strength. After the resin was pretty well dry, a second coat was applied. From there, the pieces are off to the body shop.
    Audiotech Rebirth Fiberglassing Rack
    The entire surface was soaked with resin and fiberglass mat was applied for additional str
  • Audiotech Rebirth Hole Drill
    Holes were drilled to allow the amplifier wires to pass.
  • Audiotech Rebirth Test Fit
    The panel is now back from the body shop. First, it was test fit to ensure that everything remained aligned.
    Audiotech Rebirth Test Fit
    The panel is now back from the body shop. First, it was test fit to ensure that everything
  • Audiotech Rebirth Box Secured
    The box is also back from the body shop. Here, the speakers are secured using nuts and bolts. Thread lock is used to ensure these guys don't vibrate themselves loose.
    Audiotech Rebirth Box Secured
    The box is also back from the body shop. Here, the speakers are secured using nuts and bol
  • Audiotech Rebirth Box Secured
    The speakers and forced air port are secured and the box can be sealed up.
  • Audiotech Rebirth Silicone
    A consistent bead of silicone is applied before the top is put on.
  • Audiotech Rebirth Air Nailed
    After the predrilled screws were tightened, the box top was air-nailed in place.
By Mario Escamilla
Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
0 comments
Lowrider Magazine