An additional support piece was also created and molded to the face of the joint. Focus was then shifted to the amplifier rack. The amplifiers were measured up and a clean angle was found that would allow the amplifiers to drop right into our trunk well area.Focus was then shifted to the amplifier rack. The amplifiers were measured up and a clean For better viewing, the amp board will be angle-mounted. Here, a support panel was measured.For better viewing, the amp board will be angle-mounted. Here, a support panel was measure For better viewing, the amp board will be angle-mounted. Here, a support panel was measured.For better viewing, the amp board will be angle-mounted. Here, a support panel was measure The final contours of the beauty panel are still not known, but one thing's for sure, the trim panels for the amplifiers must be square to look right.The final contours of the beauty panel are still not known, but one thing's for sure, the For the final details of the amp rack, the mock-up was taken to the well area and measured up.For the final details of the amp rack, the mock-up was taken to the well area and measured Steps were then created to support the amp trim rings. The steps were then trimmed to allow for the wires to pass through and then predrilled, screwed and routed.The steps were then trimmed to allow for the wires to pass through and then predrilled, sc The rack is now ready to be stretched and resined. Notice that the screw holes were covered.The rack is now ready to be stretched and resined. Notice that the screw holes were covere « | 1 | 2 | 3 | 4 | » | View Full Article By Mario Escamilla Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
