The parts that were removed from the engine were going to be cleaned and painted. With the engine out, the engine bay was going to get a degreasing, in order to get rid of all the grime that the car had accumulated from the past.With the engine out, the engine bay was going to get a degreasing, in order to get rid of The engine compartment was ready to receive the engine. The cast iron transmission was torn down and cleaned in the hot wash tank. The transmission housing was about to receive all new internal parts to make sure that it could hold up to the power it was going to be receiving.The transmission housing was about to receive all new internal parts to make sure that it All of the parts were inspected before the transmission was reassembled. The transmission came together smoothly. This cast iron transmission was ready to be installed. The WyoTech team carefully installed the overhauled motor back into the car. The engine had the flywheel lined up and was ready to marry the torque converter and transmission.The engine had the flywheel lined up and was ready to marry the torque converter and trans With a little persuasion, the transmission was installed without any problems. With the entire WyoTech crew behind the build, the engine was almost wrapped up, needing only minor tuning work before it would be ultimately revealed less than one week from this day.With the entire WyoTech crew behind the build, the engine was almost wrapped up, needing o SOURCE Edelbrock 2700 California St. Torrance CA 90503 310-781-2222 www.edelbrock.com WyoTech (Long Beach Campus) 2161 Technology Place Long Beach CA 90810 562-624-9530 www.wyotech.edu/campus/long_beach « | 1 | 2 | View Full Article By Saul Vargas Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
