Lowrider Cars, Girls, Pictures and Car Shows at LowRiderMagazine.com
Facebook

Grocery Getting Bass - Audiotech

Baggin' The Boom Without Sacrificing The Room.

By John Wilson, Photography by Reinaldo M. M. Robinson

Recessing the amplifiers and only displaying the faces allows the guys to protect the amplifiers and all of the wires running to them. To give a little extra pizzazz to the "grocery getter," John and Rene decided to add some LED illumination to the distribution block allowing the face to glow in a blue shimmering light with the amp cover in place.

When all is said and done, the guys from the Snake Pit have created a system for a daily driver that didn't hurt the car nor the pocket book. Created to be eye catching for a mother to go and get the goodies, this sound system also allows her to be heard before she's seen!

  • Grocery Getting Bass Routers Opening In Cosmetic Panel
    John routers the opening in the cosmetic panel to give it a more finished look.
  • Grocery Getting Bass Power Wire And Rca Signal Cables Run Behind Backseat
    Power wire and RCA signal cables are run to behind the back seat.
  • Grocery Getting Bass Enclosure Is Placed
    The enclosure is placed in the spare tire well with the amps above.
  • Grocery Getting Bass Spray Adhesive To Apply Vinyl To Face Of Enclosure
    John uses spray adhesive to apply vinyl fabric to the face of the enclosure.
  • Grocery Getting Bass Opening For Enclosure Is Cut In Cosmetic Panel
    An opening for the enclosure is cut in the cosmetic panel.
  • Grocery Getting Bass Table Saw Used To Cut Enclosure Opening
    A table saw is used to cut the enclosure opening on the metal grille.
  • Grocery Getting Bass Enclosure Placed In Hatch
    The enclosure is placed in the hatch area of the vehicle.
  • Grocery Getting Bass Audio
  • Grocery Getting Bass Grill Is Inserted
    The grille is inserted in place on the cosmetic panel.
  • Grocery Getting Bass Grill Mounted
    John mounts the grille in place after the fabric is applied.
  • Grocery Getting Bass Sprays Adhesive To Cover Cosmetic
    John sprays adhesive to the fabric that will cover the cosmetic panel.
  • Grocery Getting Bass Wrap Fabric Around The Edges
    Wrap the fabric around the edges of the cosmetic panel.
  • Grocery Getting Bass Lays Out The Amplifier
    Rene lays out the amplifier and distribution block for display.
  • Grocery Getting Bass Leds Are Used For Accent
    LEDs are used to accent the fused distribution block.
  • Grocery Getting Bass Factory Hatch Before Install
    The factory hatch area before the install.
  • Grocery Getting Bass Applies Cover Board To The Amplifier
    Rene applies the cover board to the amplifiers before the carpet is applied.
  • Grocery Getting Bass Finished System
    The finished system and cosmetic design.
  • Grocery Getting Bass Amplifiers Are Wired
    The amplifiers are wired into the system.
SOURCE
Directed Electronics
800-876-0800
directed.com 		Scosche Industries
Dept. 5.0
1550 Pacific Ave.
Oxnard, CA 93033
www.scosche.com
By John Wilson
Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!

*Please enter your username

*Please enter your password

*Please enter your comments
Comments:
Not Registered?Signup Here
(1024 character limit)
Lowrider Magazine