The height of the sleeve bag when completely compressed is approximately 4 1/2 inches, so the height from the underside of the bridge to the top of the over-axle mount should be the same.The height of the sleeve bag when completely compressed is approximately 4 1/2 inches, so With the over-axle mount positioned and the bridge placed directly over the axle, the distance was measured to determine the height of the legs for the bridge. With the over-axle mount positioned and the bridge placed directly over the axle, the dis A pair of 2-inch legs were then cut from 5x2-inch square tubing and welded under each end of the channel iron.A pair of 2-inch legs were then cut from 5x2-inch square tubing and welded under each end A cardboard template for drilling the bag mounting holes in the bridge was made and then traced onto the underside of the bridge at the outward-most positions possible (determined earlier when Michael test fit the bags on the bridge and axle).A cardboard template for drilling the bag mounting holes in the bridge was made and then t A cardboard template for drilling the bag mounting holes in the bridge was made and then traced onto the underside of the bridge at the outward-most positions possible (determined earlier when Michael test fit the bags on the bridge and axle).A cardboard template for drilling the bag mounting holes in the bridge was made and then t Two 1/2-inch holes and one 1 1/4-inch hole were drilled in the bridge where marked. The bags were then bolted to the bridge. « | 1 | 2 | 3 | » | View Full Article Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
