0602Lrm Lowrider Suspension 04 Z
HydroTech: Trailing Arms
|
Here, we take our steel flat bar and bend it to the basic shape that we need to mold and reinforce the arms. The best tools for this job are a 4-lb. hammer, a block of wood and some good force provided by you. Now the piece of flat bar will vary in width depending on your type of car. We used 131/44, but the thickness will always be 31/416-inch. Leon cautions against using metal that's thicker than 31/416, because he said it would be better to reinforce the inside of the arms rather than just making the bar thicker because all that you're really doing at that point is adding weight not strength. Back to Article
|
|