0602Lrm Lowrider Suspension 09 Z
HydroTech: Trailing Arms
We've set the arm aside for a minute to forge the cup that will replace the center of the original saddle. Once again, we used 31/416-inch thick flat steel and we also cut a section of 311/42-inch pipe. You will also want to cut the center section at about 3 inches in diameter so that you leave a gap at the edge of the pipe and the flat steel. Putting a cap on the pipe is where most street cars don't go the extra mile. Most weld in a piece of pipe to hold the spring in place and leave it uncovered. View Related Article